The Gibbl-O-Meter Sensor is a sensor added by GregTech 6 which measures compression in gibbl.
Recipe[edit | edit source]
Usage[edit | edit source]
Gibbl are equivalent to buckets of fluid trying to move (in a Pipe, or from a Boiler) that fail to because the destination is too full or does not exist.
Sensors can be rotated with a Wrench horizontally. A Monkey Wrench can be used to specify which of the five non-front sides reads the adjacent tile entity. Both tools show the helper grid, but respond to the area clicked on the sensor model itself.
Using a Screwdriver on the upper display section toggles between decimal and hexadecmial notation. Using the Screwdriver on the six buttons in the lower left increases or decreases the averaging period for readings. Using the Screwdriver on the lower right icon section rotates between sensor modes:
|00000Gb||Display raw amount|
|00000%||Display percent of maximum. Emit scaled to 0-15|
|>0000Gb||Emit 15 IF greater than set point|
|=0000Gb||Emit 15 IF equal to set point|
|<0000Gb||Emit 15 IF less than set point|
|☉0000Gb||Emit 15 if NOT equal to set point|
|=100%Gb||Emit 15 IF maximum or overflow|
|<100%Gb||Emit 15 IF less than maximum|
Many of these modes will cause the sensor block to become redstone powered under certain circumstances. While in any of the four compare to set point modes, the set point can be changed by clicking on the six buttons in the lower left with a useless item or empty hand, in the same way as the Screwdriver will change the averaging window.