Machine configuration (GregTech 6)

From Feed The Beast Wiki
Jump to: navigation, search
This page is about Machine Configuration in GregTech 6. For other uses, see GregTech 6.

GregTech 6 (GT6) adds machines and other blocks that can be manipulated, or configured. GT6 has several specialized ways to configure its blocks, including block overlays and specific modifications based on the tool type used. In addition, most GregTech 6 machines can only be rotated horizontally, and have input and output (both internally and externally automated optionally) of both items and fluids on certain sides relative to the front.

Rotation and connection[edit | edit source]

If CodeChickenLib is installed, pointing the crosshair at a rotatable or connectable GregTech block while holding a tool applicable to that block will show a grid similar to the one below. In addition, if the block is connectable some of the sections will have 'X'es over them if the block is connecting in that direction.

GTWrenchOverlay.png

The machine face is divided into nine sections. Each section represents a different side of the machine:

GTWrenchOverlayNumbered.png

Each section may be right-clicked to move the output to a given face of the machine:

  • Section 5 (the center) will use the tool on the side that is clicked on.
  • Sections 1,3,7,9 (the corners) will use the tool on the side opposite the one that is clicked.
  • Sections 2,4,6,8 (the sides) will use the tool on the side corresponding to the direction indicated by the section.
    For example, when pointing at the front of the machine and right clicking on Section 2, the tool will be used on the block's top face.