The Sequencer is a Redstone logic machine added by RFTools. It is used to send a pre-programmed sequence of Redstone logic pulses in response to a signal.
Recipe[edit | edit source]
Sequencer Interface[edit | edit source]
The Sequencer's interface consists of an 8x8 grid of dots that represent logical ON/OFF states, Clear and Fill buttons that turn all the dots on or off, a mode selector and a delay setting. The mode selector offers 8 choices:
- Once1 - Runs the sequence only once. Ignores further input until the sequence is complete.
- Once2 - Runs the sequence only once. Restarts if another input arrives.
- Loop1 - Run the sequence on a continuous loop. Ignore all inputs.
- Loop2 - Run the sequence continuously, restarting on input pulses.
- Loop3 - Run the sequence while input signal is high. Remember position and resume.
- Loop4 - Run the sequence while input is high. Restart on no signal.
- Step - Step through the sequence, progressing one step with each input pulse.
Further information[edit | edit source]