Range Trigger

(tagline)
(jumpto) (jumptonavigation)(comma-separator) (jumptosearch)
Range Trigger

ModIC2 Nuclear Control
TypeMachine

The Range Trigger is a block added by IC2 Nuclear Control. It is used to monitor a variety of cards, although before version 2.2.0a it could only measure the Energy Sensor Location Card.

In the GUI, the player can configure two numbers. If the value the card monitors (it depends on the card) goes above the higher number set, or under the lower number set, a redstone signal will be emitted. This can be used to trigger some sort of warning like a Howler Alarm. The redstone signal can be inverted.

The Range Trigger may require one or more Range Upgrades if it's target is too far away.

Recipe[(editsection)(pipe-separator)(visualeditor-ca-editsource-section)]

Current[(editsection)(pipe-separator)(visualeditor-ca-editsource-section)]

The recipe was changed after version 2.2.0a.

Classic[(editsection)(pipe-separator)(visualeditor-ca-editsource-section)]

GregTech[(editsection)(pipe-separator)(visualeditor-ca-editsource-section)]


(tpt-languages-legend)
English(tpt-languages-separator)‎中文(中国大陆)‎